Looking for:
Ultimaker 3 feeder problem free
Ultimaker 3 feeder problem free
Printer Two is even worse. Feeding filament into extruder two is nearly impossible. Filament doesn't smoothly pass through. It takes a few. Issue: Axial fan (the front fan) was blocked by debris, thus the feed in the printhead would overheat and the material would get to soft. The feeder is working when I load filament. I am not sure about the middle fan. Is that the fan on the printcore door? Since I can load filament.
❿
Ultimaker 3 feeder problem free.Feeding Problems - Ultimaker 3D printers - Ultimaker Community of 3D Printing Experts
Followers 3. Link to post Share on other sites More sharing options❿
❿
Comments
Post a Comment